Cement Plant Suction Filter WU-400x180F-J

The special filter element for the oil suction port of the oil tank of the thin oil station, the filter element is made of stainless steel mesh, which is easy to filter and remove large particles in the oil.

An electric contact thermometer is installed in the oil tank, which is used to measure the temperature of the oil and control the on and off of the electric heater in the oil tank. When the oil temperature is lower than 20°C, the electric heater is automatically started to heat the oil, and when the oil temperature rises to 30°C, the electric heater is automatically cut off. Another electric contact thermometer is installed at the outlet of the oil supply system. When the displayed oil supply temperature is higher than 55°C, an alarm signal will be issued, the water inlet shut-off valve of the cooler will be opened manually, and the cooler will be put into operation. When the oil temperature drops to 40°C, a low temperature signal is issued, and the water inlet shut-off valve of the cooler needs to be closed manually. 4. The thin oil station control system can adopt the above-mentioned centralized control and manual control by the machine, and the switch can be switched between them. Centralized control and motor chain start and stop, manual control is to start and stop the gear pump or electric heater at the side of the machine after the motor stops. 5. The mill must not be forced to start under any of the following conditions. (1) When the outlet pressure of the gear pump is lower than the set "normal oil pressure value".

Hot Tags: cement plant suction filter wu-400x180f-j, China, suppliers, customized, quotation, for sale, Cement Plant Filter Element, Replacement For South Lubrication Filter Element, Replacement For SICHUAN CRUN Filter Element, Replacement For Huali Hydraulic Lubrication Filter Element, Replacement Filter Element For Jiangsu South Lubrication NDQ 150